Telfordways

Every work of Thomas Telford, the Colossus of Roads

Bridges · England

Cantlop BridgeIron bridge by Thomas Telford (1813), Shropshire, England

Cantlop Bridge, an iron bridge by Thomas Telford in Shropshire
Photo: Cantlop Bridge 2016 by DeFacto, CC BY-SA 4.0
Span lengths of nine Telford arch bridges, highlighting Cantlop (1813) Horizontal bars to scale show the arch spans of nine of Telford's bridges. Cantlop (1813) 9.5 m Montford (1792), 3 spans 17.7 m centre Bewdley (1797-9), 3 spans 18.3 m centre Waterloo, Betws-y-Coed (1815) 32.0 m Buildwas (1796, demolished) 39.6 m Holt Fleet (1828) 45.7 m Over (1830) 45.7 m Aldford (1824) 50.0 m Mythe (1826) 51.8 m 01020 m ARCH SPANS TO SCALE Nine of Telford's arch bridges · span lengths only
Span lengths only are drawn, to scale, from the listings and standard references; arch shape, rise and piers are not shown. Dark bars are cast iron and pale bars are stone. Multi-span bridges show each span end to end.
Type
Iron bridge
Built
1813
Where
ShropshireEngland
Today
Standing (English Heritage)
Telford's part
Design approved by Telford
Location
52.6518, -2.7148

Cantlop Bridge is a small cast-iron road bridge over Cound Brook in Shropshire, built in 1813 to a design approved by Telford. English Heritage cares for it, and it is the only Telford-approved cast-iron bridge in Shropshire still standing where it was built.

What you are looking at

Historic England describes a single segmental span of 9.5 metres, made of four parallel arched cast-iron ribs braced to each other and carrying five cross members. The abutments are of red and grey sandstone, and the cast-iron railings have dog rails and shaped balusters.

A plaque once on the bridge read 'Thomas Telford Esqr Engineer 1818', but it has gone. Some sources therefore give 1818 for the bridge, while the listing dates it 1813.

Who built it

The listing says it is unclear whether Telford personally designed the bridge, because he did not list it in his own account of his work, but that it appears to have been built to a design he approved. This section of the Shrewsbury to Acton Burnell road was turnpiked in 1797, when the crossing was still a narrow bridge.

It carried the Shrewsbury to Pitchford road until it was closed to vehicles in the 1960s, after a new bridge was built nearby. For the same brook see Cound Arbour Bridge.

Visiting

Check locally before you travel, as access and use can change.

Questions people ask

When was Cantlop Bridge built?

In 1813, according to Historic England and English Heritage.

Did Telford design it?

The listing says he approved the design, and it is unclear whether he drew it.

How long is the span?

9.5 metres.

Can I cross it?

It is on foot only, because it was closed to vehicles in the 1960s.

On the map

Open on the full map · Directions

Nearby Telford works

More bridgesBack to the map