Telfordways

Every work of Thomas Telford, the Colossus of Roads

Bridges · Wales

Menai Suspension BridgeSuspension bridge by Thomas Telford (1826), Anglesey / Gwynedd, Wales

Menai Suspension Bridge, a suspension bridge by Thomas Telford in Anglesey / Gwynedd
Photo: Y Fenai a Phont y Borth - Menai Staits and the Menai Suspension Bridge, Wales 02 (cropped) by Monsyn, CC BY-SA 4.0
Elevation of the Menai Suspension Bridge, drawn to scale A side view of Telford's suspension bridge: a 176 metre main span hung from chains over two stone towers, with seven stone approach arches, the deck about 30 metres above high water. 176 m · 579 feet 30 m · 100 ft Anglesey Bangor Menai Strait · water level at high tide ELEVATION OF THE MENAI SUSPENSION BRIDGE A5 over the Menai Strait · 16 chains · 7 approach arches · opened 30 January 1826 050100 m
Span, deck height, tower height and the seven approach arches are drawn to scale from published dimensions. Tower profiles, arch widths and chain sag are approximate.
Type
Suspension bridge
Built
1826
Where
Anglesey / GwyneddWales
Today
Standing / in use
Telford's part
Designer
Location
53.2203, -4.1630approximate

When it opened on 30 January 1826, the Menai Suspension Bridge had the longest span of any bridge in the world. It carries the A5 over the Menai Strait between Anglesey and the mainland, and it finished Telford's road from London to Holyhead.

What you are looking at

A single deck hangs from sixteen chains, in four sets of four, slung between two tapering stone towers about 176 metres (579 feet) apart. Each tower is faced in limestone from Penmon on Anglesey and is hollow inside, braced by cross-walls. Seven stone arches carry the road to the towers, four on the Anglesey side and three on the mainland side. The chains pass over the tops of the towers on cast-iron saddles that rest on rollers, so they can slide a little as the iron warms and cools. Beyond the arches they run down into tunnels cut deep into the rock, where they are anchored.

The deck is about 30 metres (100 feet) above high water. That figure drove the whole design. The Admiralty insisted that tall sailing ships must still be able to pass beneath, and a bridge on piers in the strait could not have given the clearance without a long, steep approach. Hanging the road from chains left the channel open and the banks did the rest.

Who built it

Parliament authorised the bridge in 1819, and Telford designed it as the final link in the London to Holyhead road. The first stone was laid on 10 August 1819. William Hazledine made the wrought iron at his Upton forge near Shrewsbury, and each bar was tested at his Coleham works before it was pinned into a chain and hoisted into place. Each of the sixteen chains is made of five parallel bars of 935 links and is about 522 metres long. Nothing this long had been attempted before.

Before the bridge, the crossing was by ferry, and a bad tide could make it dangerous. The bridge cut the journey from London to Holyhead by about nine hours.

What changed after 1826

The first deck was a timber roadway only 24 feet wide, with no stiffening, and wind soon set it heaving. W. A. Provis strengthened it in 1840. The timber was replaced with steel in 1893. In 1938 to 1940 the wrought-iron chains were replaced with steel ones, designed by Sir Alexander Gibb for Dorman Long and swapped chain by chain with the bridge kept in use. The new chains follow the original curve, so the bridge you see keeps Telford's outline. The listing for the bridge is Grade I.

It has a neighbour. Robert Stephenson's Britannia Bridge, built to carry the railway, opened a short way along the strait in 1850. It was rebuilt after a fire in 1970 and now carries the A55 on a road deck above the railway.

Visiting

Closures, hours and works change often. Check Traffic Wales before you travel.

Questions people ask

How long is the Menai Suspension Bridge?

The whole structure is 417 metres (1,368 feet) long. The main span between the towers is about 176 metres (579 feet), and some sources give it as 577 or 580 feet.

How high is it above the water?

The deck is about 30 metres (100 feet) above high water, set by the Admiralty requirement that ships could sail under it.

When was it built?

Work began in 1819 and the bridge opened on 30 January 1826. It reached its 200th anniversary in 2026.

Is it the original bridge?

The towers, arches and overall shape are Telford's. The deck has been replaced, and the original wrought-iron chains were replaced with steel in 1938 to 1940.

Can you drive across it?

At present vehicles under 7.5 tonnes can, subject to works and closures. Check Traffic Wales first.

Did Telford build the only bridge here?

No. Stephenson's Britannia Bridge, completed in 1850 and rebuilt in the 1970s, stands alongside it and now carries both the railway and the A55. The Telford bridge was the first crossing of the strait.

On the map

Open on the full map · Directions

Nearby Telford works

More bridgesBack to the map