Telfordways

Every work of Thomas Telford, the Colossus of Roads

Churches · Scotland

North Ballachulish Parliamentary KirkChurch by Thomas Telford (1829), Lochaber, Scotland

Standard Parliamentary kirk, schematic Front elevation and plan of the standard Telford Parliamentary church: a rectangular church with two arched doors and two arched windows on the front, a bellcote on one gable, and a rear wing. bellcote small cross door door pair of windows FRONT ELEVATION front wall 52 ft 6 in (16 m), to scale pulpit(position schematic) seating for 312 (not drawn) door door rear wing (most, not all) PLAN THE STANDARD PARLIAMENTARY KIRK (SCHEMATIC) Built 1825–30 under the Act of 1823 · plan drawn up by William Thomson for Telford's office
Only the length of the front wall, 52 ft 6 in (16 m), is to scale, and the plan is drawn to the same width. All other proportions are schematic. The layout follows the Historic Environment Scotland listing for Kinlochbervie and published descriptions. This is the standard design the Parliamentary churches were built to, not a drawing of this particular church.
Type
Church
Built
1829
Where
LochaberScotland
Today
Altered Rebuilt
Telford's part
Designer (standard plan)
Location
56.7005, -5.1935

North Ballachulish Parliamentary Church in Lochaber was one of the 32. It was demolished and replaced.

What you are looking at

The church has gone. Sources differ on the replacement: Canmore gives 1900, the Highland HER 1911.

Who built it

The Parliamentary churches came from an Act of 1823, amended in 1824, which gave £50,000 for new churches and manses in the Highlands and Islands, with a limit of £1,500 for each site. Thirty-two churches were built between 1825 and 1830. Telford's office supplied a standard design, a rectangular church seating 312 (most had a rear wing, making a T), drawn up by William Thomson, together with specimen designs for the manses. It was built in 1829.

Three of the churches are Category A listed: Croick, Plockton and Ullapool.

Visiting

Check locally before you travel, as access and use can change.

Questions people ask

Who designed it?

It was built to the standard Parliamentary church design that Telford's office supplied, and the plan was drawn up by William Thomson. Telford did not design each church individually.

When was it replaced?

Sources differ: 1900 according to Canmore, 1911 according to the Highland HER.

On the map

Open on the full map · Directions

Nearby Telford works

More churchesBack to the map